E21-4D25
All Products

E21-4D25 Emulsifier

from 1,700.00

Microflow CVO’s E21-4D25 emulsifier is designed for creating microemulsions by flowing a dispersed phase stream through very small orifices into a continuous phase stream.  This device also has an addition stage for dilution or quenching emulsion reactions.

Surface:
Quantity:
Add To Cart
E21-4D25

Additional Info

Microflow CVO E21-4D25 Emulsifier with Dilution/Quench Stage

Microflow CVO’s E21-4D25 emulsifier is designed for creating microemulsions by flowing a dispersed phase stream through very small orifices into a continuous phase stream.  This device also has an addition stage for dilution or quenching emulsion reactions.  The E21-4D25 device has been used to create a uniform distribution of 30um microspheres.  Note droplet or microsphere sizes are dependent upon the chemistry system and flow conditions, so some trials will likely be necessary to determine optimal conditions for your process.

The E21-4D25 emulsifier is sized for the following nominal flow rates (1cP fluid at 5 psi):

·         Dispersed phase = 1.3 ml/min

·         Continuous phase = 2.7 ml/min (2:1 CP to DP ratio)

·         Dilution/Quench = 21 ml/min (5:1 dilution of emulsion stream)

·         Total flow = 25 ml/min

The E21-4D25 made of 316 stainless steel and has 1/8” OD inlet and outlet tubes.  Standard compression fittings with stainless steel ferrules are appropriate for connecting to the E21-4D25 tubes.  The E21-4D25 can be operated at very high pressures (several thousand psi) and temperatures (over 800°C) , enabling special reaction conditions such as maintaining liquid phase above boiling points and supercritical conditions.

If transitioning to or from polymer tubing, nylon ferrules should be used on the polymer tubing end of the connector. 

A 15um or smaller inline filter on the dispersed phase inlet is highly recommended.

E21-4D25 diagram.JPG